Edge CTS Manuel d'utilisateur télécharger pdf (Page 16)

HARDWARE INSTALLATIONS

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

7) If you haven’t done so al-

ready, plug the 6 pin cable into

its mating connector on the back

of the CS or CTS. Figure 25

NOTE: The OBDII cable also

needs to be attached in order

for the CS or CTS to power up.

EAS CONNECTOR

OBDII CONNECTOR

Figure 25

8) Turn the key-on in your ve-

hicle. Follow all on-screen in-

structions until the main gauge

screen is displayed.

NOTE: It is necessary for your

CS or CTS device to be pow-

ered up so that it can recognize

that you have installed an EAS

device. This will need to be

done prior to using MyStyle®

to conﬁ gure settings. See My-

Style® section for more infor-

mation.

Your Universal Sensor hard-

ware installation is complete.

NOTE: You may have noticed

that there is a sticker on each

of the Universal Sensor Con-

nectors. The letters on the

stickers, either A or B lets you

know which sensor you have

plugged into. Do not remove

them. Refer to the Mystyle

section of this manual for more

information.

Figure 26

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Pas de commentaire

Edge CTS Manuel d'utilisateur Page 16