Edge CTS Manuel d'utilisateur télécharger pdf (Page 31)

MYSTYLE SOFTWARE

31

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

Figure 51

4) Fill in the Unit of Measure

value. This will be displayed

on the main gauge screen. Only

4 digits are allowed.

5) Input the chart data. Most

sensors will have data sheets

that contain a chart of values

that you can input into the

Mystyle chart. These will look

similar to the charts in Fig-

ures 49 and 50 on the previous

pages.

For non-linear output sensors,

the more data points you can

enter, the more accurate your

custom mapping will be. When

the sensor output is linear, only

the maximum and minimum

values are needed.

NOTE: You probably noticed

the button in the upper right

hand corner labeled “Switch to

CNG”. Edge offers CNG kits

for ﬂ eet vehicles, which are not

yet available to individual us-

ers. This allows them to modi-

fy a PID that uses temperature

and pressure to calculate the

fuel level in their CNG tank.

7) Click the “Save” button,

and you will be directed to the

previous screen.

8) Click the “Save Conﬁ gu-

ration” button to upload the

changes to your CS/CTS.

EGT SENSOR

If you are modifying an EGT

Device, note that you are only

allowed to change the names

and descriptions.

1) Update/change names and

description.

2) Click the “Save” button,

and you will be directed to the

previous screen.

3) Click the “Save Conﬁ gu-

ration” button to upload the

changes to your CS/CTS.

CS/CTS SETUP

Now that you have modiﬁ ed

and saved your Mystyle data,

you can setup and display your

EGT or Universal Sensor Input

PIDs on the CS/CTS device.

1) Disconnect your CS/CTS

from Mystyle, and reinstall the

device in your truck.

2) Follow all on-screen instruc-

tions until your main gauge

screen is displayed.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire